How to avoid the ceramic tile sticking

发布时间：2015-08-21

   Only need to pay attention to the following 4 aspects of the decoration process:
   1, clean up the basic level of tiling
   Such as lime paste, latex paint, wallpaper and other decorations on the wall, or on the ground there is dirt, be sure to clean up, or cement mortar and the base bond unstable; in addition, if the wall itself has cracks should be properly treated before sidewalks, to avoid changes in the future to basic structural cracks in brick wall cracking and peeling; and for the flatness and verticality of the gap is too wide to the ground, walls, but also with cement mortar leveling treatment. Shop before the color difference between the tiles.
   2, wall brick to fully soak
   Because the wall brick has a high moisture content, the characteristics of the paste must be taken into account. Tiling of grassroots should fully watering humid. Otherwise, mortar water is dry grass and tile rapid absorption and rapid condensation, effect on the bonding fastness. Otherwise, the wall will absorb moisture from the cement, the cement can not play the role of the bonding agent.
   3, paving the floor tiles to pave the ground
   Will not spread the cement tiles shop on the ground, beaten, the cement slurry painted tiles, shop on the ground, the diagonal position of the four brick flush. And the laying of the order is also pay attention to. Paste within the tile should be posted outside, such as ground slope or leak, should pay attention to according to the direction of the drainage slope to find; wall tiles should be to covered, for aesthetic purposes, should be the bottom of brick and paste. The wall sticking after tile press. The other side of the wall, not a stick to the top, to prevent collapse caused by tile greater weight. Lay the floor tile in a short time don't trample.
   4, ceramic tile as much as possible.
   Summer, because material than ordinary drier, so for slabs, tiles and other need to immerse themselves in water treatment of the material, to immerse themselves in water treatment for a prolonged time, the water close to saturation state. This will not float to the surface in the preliminary because dry tiles and from the cement in the condition of water, which occurred with the cement bonding is not strong, thrown hollowing, shedding phenomenon, and give you bring some unnecessary trouble.
   To cater to the pursuit of trendy consumers, appearing on the market the some new techniques, such as ceramic tile adhesive, colorful sealant, leaving the seam paving. Ceramic tile adhesive agent (also called dry paste method), tiles do not need pre soaking the base face without wet, as long as the basic premise of pavement is good may, homework situation has been greatly improved.